Lenovo ThinkSystem NE1032, Руководство по установке

Страница: 51 / 112

© Copyright Lenovo 2018 Chapter 3: Installing NE1032 Hardware and Options
51
Installing Port Transceivers
The NE1032 supports copper and optical transceivers.
To install a supported transceiver, see the following sections:
 “Installing an SFP Copper Transceiver” on page 51
 “Installing an SFP Optical Transceiver” on page 52
 “Installing an SFP+ Optical Transceiver” on page 53
Installing an SFP Copper Transceiver
Approved 1 GbE SFP copper transceivers are supported in some breakout adapters
that can be installed in SFP+ port slots. The SFP copper transceiver provides an RJ45
connector that accepts a standard 10/100/1000BASE-T (Category 5) cable.
Approved 1 GbE SFP copper transceivers are supported in G8296 SFP+ port slots.
The SFP copper transceiver provides an RJ45 connector that accepts a standard
10/100/1000BASE-T (Category 5) cable in 100/1000T base T mode. When used in 10
GbE mode, you must use CAT6 copper cabling.
To install an SFP copper transceiver in an SFP+ port slot on the switch, complete the
following steps.
Note:
To avoid damage to the cable or the SFP transceiver, do not connect the cable
before you install the transceiver.
1.
Remove the safety cap and pull the locking lever into the down (unlocked)
position.
2.
Insert the transceiver into the slot until it clicks into place. Use minimal pressure
when you insert the transceiver. Do not use excessive force when you insert the
transceiver or you might damage the transceiver or the slot.
Note:
The transceiver has a mechanical guide key to prevent you from inserting
the transceiver in an incorrect orientation.
3.
Pull up the locking lever to lock the transceiver into place.
4.
Connect the cable following the “Cabling Guidelines” on page 36 .
To remove an SFP copper transceiver, disconnect the cable, and pull down the
locking lever to release the transceiver. After you remove the transceiver, replace the
safety cap.