Lenovo ThinkPad T470 20HD, Руководство по техническому обслуживанию аппаратной части, Страница: 43 / 116

• The system administrator can set the same supervisor password on many ThinkPad notebook computers
to make administration easier.
Attention: If the supervisor password has been forgotten and cannot be made available to the service
technician, there is no service procedure to reset the password. The system board must be replaced for a
scheduled fee.
How to remove the power-on password
To remove a power-on password, do the following:
If no supervisor password has been set, do the following to remove the power-on password:
1. Turn off the computer.
2. Remove the removable battery. For instructions on how to remove the removable battery, see “1010
Removable battery” on page 68.
3. Remove the built-in battery. For instructions on how to remove the built-in battery, see “1120 Built-in
battery” on page 83.
4. Remove the coin-cell battery. For instructions on how to remove the coin-cell battery, see “1100 Coin-
cell battery” on page 81. Wait for a few seconds.
5. Reinstall the coin-cell battery. For instructions on how to install the coin-cell battery, see “1100 Coin-cell
battery” on page 81.
6. Reinstall the built-in battery. For instructions on how to reinstall the built-in battery, see “1120 Built-in
battery” on page 83.
7. Reinstall the removable battery. For instructions on how to install the removable battery, see “1010
Removable battery” on page 68.
8. Turn on the computer and wait until the power-on self-test (POST) ends. After the POST ends, the
password prompt does not appear. The power-on password has been removed.
If a supervisor password has been set and is known to the service technician, do the following to remove the
power-on password:
1. Turn on the computer.
2. When the logo screen comes up, immediately press F1.
3. Type the supervisor password to enter the ThinkPad Setup program.
4. Select Security .
5. Select Password .
6. Select Power-On Password .
7. Type the current supervisor password in the Enter Current Password field. Then leave the Enter New
Password field blank, and press Enter twice.
8. In the Changes have been saved window, press Enter.
9. Press F10 to save changes and exit the ThinkPad Setup program.
How to remove the hard disk password
Attention: If User only mode is selected and the user hard disk password has been forgotten and cannot be
made available to the service technician, neither Lenovo nor Lenovo authorized service technicians provide
any services to reset the user hard disk passwords or to recover data from the hard disk drive. To put the
system back to operational status, the only Lenovo and Lenovo-authorized service solution would be to
replace the hard disk drive or solid-state drive with a scheduled fee.
To remove a user hard disk password that has been forgotten, when the supervisor password and master
hard disk password are known, do the following:
Chapter 4
.
Related service information
37