Lenovo ThinkPad T400s, Руководство по техническому обслуживанию аппаратной части

Страница: 57 / 198

FRU tests
The following table shows the test for each FRU.
Table 1. FRU tests
FRU Applicable test
System board 1. Diagnostics --> CPU/Coprocessor
2. Diagnostics --> Systemboard
3. If the docking station or the port replicator is attached to the
ThinkPad Notebook, detach it.
4. Place the computer on a horizontal surface, and run
Diagnostics
-->
ThinkPad Devices
-->
HDD Active Protection
Test .
Note: Do not apply any physical shock to the computer while
the test is running.
Power Diagnostics --> ThinkPad Devices --> AC Adapter , Battery 1
(Battery2)
LCD unit 1. Diagnostics --> Video Adapter
2. Interactive Tests --> Video
Audio Enter the BIOS Setup Utility and change Serial ATA (SATA) setting
to
Compatibility , and run Diagnostics --> Other Device -->
Conexant Audio
Speaker
Interactive Tests
-->
Internal Speaker
Note: Once Audio test is done, the no sound is heard this test. In
this case, turn off and turn on the computer. Then, run this test
again.
Keyboard 1. Diagnostics --> Systemboard --> Keyboard
2. Interactive Tests --> Keyboard
Hard disk drive or
solid state drive Enter the BIOS Setup Utility and change Serial ATA (SATA) setting
to
Compatibility , and run Diagnostics --> Fixed Disks
You can also diagnose the drive without starting up the operating
system. To diagnose the drive from the BIOS Setup Utility, do as
follows:
1. Remove any diskette from the diskette drive, and then turn off
the computer.
2. Turn on the computer.
3.
While the message, “To interrupt normal startup, press the
blue ThinkVangate button,” is displayed at the lower left of the
screen, press F1 to enter the BIOS Setup Utility.
4. Using cursor keys, select HDD diagnostic program . Press
enter.
5. Using cursor keys, select Main hard disk drive or Ultrabay
hard disk drive .
6. Press Enter to start the diagnostic program.
Diskette drive 1. Diagnostics --> Diskette Drives
2. Interactive Tests --> Diskette
Optical drive 1. Diagnostics --> Other Devices --> Optical Drive
2. Interactive Tests
-->
Optical Drive Test
Memory
1.
If two DIMMs are installed, remove one of them and run
Diagnostics --> Advanced Memory Tests .
2.
If the problem does not recur, return the DIMM to its place,
remove the other one, and run the test again.
General checkout
49