Lenovo ThinkAgile CP, Замена аппаратных компонентов и процедуры технического обслуживания

Страница: 79 / 162

ThinkAgile Advantage completes the following step:
Step 7. ThinkAgile Advantage signs in to the primary interconnect. The username is
admin
and the
password is the one you set during the installation.
The solution administrator completes the following steps:
Step 8. Run the following command on the primary interconnect:
> > ssu ud do o sseerrvviiccee ttaaccp p--n neettw wo orrkk--cco on nttrro olllleerr rreessttaarrtt
ThinkAgile Advantage completes the following step:
Step 9. ThinkAgile Advantage gathers the relevant information, contacts support, and requests a hardware
removal from the database by providing the serial number.
The removal of the storage controller is now complete.
After removing the storage controller:
• Install a new storage controller. See “Install a hot-swap storage controller” on page 71
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a hot-swap storage controller
This procedure explains how to add a storage controller to the ThinkAgile CP configuration, assuming a
storage controller has been previously removed.
Procedure performed by
: customer or field service
To install a hot-swap storage controller, complete the following steps:
The customer or field service preforms the following steps:
Step 1. Ensure that the release latch is in the open position. Slide the canister all the way into the
enclosure.
Step 2. Secure the storage controller by rotating the release latch until it clicks into the closed position.
Figure 27. Hot-swap storage controller installation
Chapter 5
.
Part replacement and maintenance procedures
71