Lenovo System x3650 M4 HD, Инструкция по установке и обслуживанию

Страница: 119 / 1168

Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the system-event log. Also, after you complete a repair or correct an error, clear the system-event
log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error messages.
– System Event Log
Select this choice to view the system event log.
– Clear System Event Log
Select this choice to clear the system event log.
• User Security
Select this choice to set, change, or clear passwords. See “Passwords” on page 107 for more information.
This choice is on the full and limited Setup utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. See “Power-on password:” on page 108
for more information.
– Clear Power-on Password
Select this choice to clear a power-on password. See “Power-on password:” on page 108 for more
information.
– Set Administrator Password
Select this choice to set or change an administrator password. An administrator password is intended
to be used by a system administrator; it limits access to the full Setup utility menu. If an administrator
password is set, the full Setup utility menu is available only if you type the administrator password at
the password prompt. See “Administrator password:” on page 109 for more information.
– Clear Administrator Password
Select this choice to clear an administrator password. See “Administrator password:” on page 109
for more information.
• Save Settings
Select this choice to save the changes that you have made in the settings.
• Restore Settings
Select this choice to cancel the changes that you have made in the settings and restore the previous
settings.
• Load Default Settings
Select this choice to cancel the changes that you have made in the settings and restore the factory
settings.
• Exit Setup
Select this choice to exit from the Setup utility. If you have not saved the changes that you have made in
the settings, you are asked whether you want to save the changes or exit without saving them.
Passwords
From the User Security menu choice, you can set, change, and delete a power-on password and an
administrator password.
The User Security choice is on the full Setup utility menu only.
If you set only a power-on password, you must type the power-on password to complete the system startup
and to have access to the full Setup utility menu.
Chapter 3
.
Configuration information and instructions
107