Lenovo RackSwitch G8264CS, Справочник команд интерфейса командной строки

Страница: 22 / 702

22
G8264CS Command Reference for ENOS 8.4
ISCLI Command Modes
The ISCLI has three major command modes listed in order of increasing privileges,
as follows:
 User EXEC mode
This is the initial mode of access. By default, password checking is disabled for
this mode, on console.
 Privileged EXEC mode
This mode is accessed from User EXEC mode. This mode can be accessed using
the following command:
enable
 Global Configuration mode
This mode allows you to make changes to the running configuration. If you save
the configuration, the settings survive a reload of the G8264CS. Several
sub ‐ modes can be accessed from the Global Configuration mode. For more
details, see Table 2 . This mode can be accessed using the following command:
configure terminal
Each mode provides a specific set of commands. The command set of a
higher ‐ privilege mode is a superset of a lower ‐ privilege mode—all lower ‐ privilege
mode commands are accessible when using a higher ‐ privilege mode.
The following table lists the ISCLI command modes.
Table 2. ISCLI Command Modes
Command Mode/Prompt Command used to enter or exit
User EXEC
RS G8264CS>
Default mode, entered automatically on console
Exit:
exit
or
logout
Privileged EXEC
RS G8264CS#
Enter Privileged EXEC mode, from User EXEC mode:
enable
Exit to User EXEC mode:
disable
Quit ISCLI:
exit
or
logout
Global Configuration
RS G8264CS(config)#
Enter Global Configuration mode, from Privileged EXEC mode:
configure terminal
Exit to Privileged EXEC:
end
or
exit
Interface IP
RS G8264CS(config ­ ip ­ if)#
Enter Interface IP Configuration mode, from Global
Configuration mode:
interface ip
<1 ‐ 128>
Exit to Global Configuration mode:
exit
Exit to Privileged EXEC mode:
end