Lenovo IdeaPad Slim 1, Руководство по техническому обслуживанию аппаратной части

Страница: 33 / 60

Chapter 4. Removing a FRU or CRU
Service tools
The following table lists tools for servicing Lenovo computers. Tools with a cross mark are needed for
servicing the product models as described by this publication. Prepare them before you service the product.
Table 4. Service tools
Service tool and consumable
Model applicability
Screwdriver (Phillips head) (PH1/PH01) X
Screwdriver (Torx head) (T5)
Screwdriver (Torx head) (T30)
Pry tool 1 X
Tweezers (conductive) X
Tweezers (isolated)
Suction cup
Hexagonal socket
Silicone grease
Acetate tape X
Polyamide tape
Mylar tape
Electrical tape
Double-sided tape
Conductive tape
Eraser
Heat gun
Brown brush
Notes:
• T30 screwdrivers are used to service the new Intel Xeon CPUs.
• Hexagonal sockets are used to remove antenna connectors.
• Silicone grease is applied to the CPU and heat sink surfaces to eliminate air gaps.
General guidelines
When removing or replacing a FRU, ensure that you observe the following general guidelines:
1. Do not try to service any computer unless you have been trained and certified. An untrained person runs
the risk of damaging parts.
2. Begin by removing any FRU that have to be removed before replacing the failing FRU. Any such FRU are
listed at the beginning of each FRU replacement procedure. Remove them in the order in which they are
listed.
© Copyright Lenovo 2019
27