Lenovo HR630X V2, Руководство пользователя

Страница: 100 / 134

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the RAID super capacitor module to any
unpainted surface on the outside of the server. Then, take the RAID super capacitor module out of
the package and place it on a static-protective surface.
Step 2. Install the RAID super capacitor module on the riser.
Figure 69. Installation of the RAID super capacitor module on the riser
a. Open the retention clip on the holder.
b. Put the RAID super capacitor module into the holder and press it down to secure it into the
holder.
c. Rotate the latch on the riser bracket to the open position.
d. Align the RAID super capacitor assembly with the slot on the riser card. Then, carefully press
the RAID super capacitor assembly straight into the slot until it is securely seated and its
bracket also is secured.
After you finish
1. Install the riser assembly on the chassis. See “Install a riser card” on page 95.
2. Connect the super capacitor module to an adapter with the extension cable that comes with the super
capacitor module.
3. Complete the parts replacement. See “Complete the parts replacement” on page 110.
Riser card replacement
Use this information to remove and install a riser card.
There are different types of riser assembly configurations. The removal or installation procedure of the riser
card is similar for all types of riser assembly. The following takes the LP-FH riser assembly as an example.
Remove a riser card
Use this information to remove a riser card.
92
HR630X V2 User Guide