Lenovo 7D8T, Руководство по обслуживанию

Страница: 138 / 218

Figure 123. Removing a PHM
Fully loosen the Torx T30 nuts on the PHM
in the removal sequence shown
on the heat-sink
label.
Rotate the anti-tilt wire bails inward.
Carefully lift the PHM from the processor socket. If the PHM cannot be fully lifted out of the
socket, further loosen the Torx T30 nuts and try lifting the PHM again.
Notes:
• Do not touch the contacts on the bottom of the processor.
• Keep the processor socket clean from any object to prevent possible damages.
After this task is completed
• The processor socket must always contain a cover or a PHM. When removing or installing a PHM, make
sure to protect empty processor sockets immediately with a cover.
• If you are removing the PHM as part of a system board replacement, set the PHM aside.
• If you are reusing the processor or heat sink, separate the processor from its retainer. See
“Separate the
processor from carrier and heat sink” on page 130
• If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Separate the processor from carrier and heat sink
This task has instructions for separating a processor and its carrier from an assembled processor and heat
sink, known as a processor-heat-sink module (PHM). This procedure must be executed by a trained
technician.
About this task
130
ThinkEdge SE450 Maintenance Manual