Lenovo 7D8J, Руководство по установке, Страница: 109 / 122

Selecting a startup device
If the server does not start up from the expected device, you can either change the startup device sequence
or select a temporary startup device.
Changing the startup device sequence permanently
To change the startup device sequence permanently, complete the following steps:
Step 1. Depending on the type of the storage device, do one of the following:
• If the storage device is internal, skip to Step 2 the next step on page 105.
• If the storage device is a disc, ensure that your server is turned on. Then, insert the disc into the
optical drive.
• If the storage device is an external device other than a disc, connect the storage device to the
server.
Step 2. Start the Setup Utility program, see “Starting the Setup Utility program” on page 101.
Step 3. Select
Startup
➙
Boot Priority Order
.
Step 4. Follow the instructions on the right side of the screen to change the startup device sequence.
Step 5. To save settings and exit the Setup Utility program, press
F10
; then, select
Yes
in the displayed
window, and press
Enter
.
Selecting a temporary startup device
Note:
Not all discs and storage drives are applicable as startup device.
To select a temporary startup device, complete the following steps:
Step 1. Depending on the type of the storage device, do one of the following:
• If the storage device is internal, skip to Step 2 the next step on page 105.
• If the storage device is a disc, ensure that your server is turned on. Then, insert the disc into the
optical drive.
• If the storage device is an external device other than a disc, connect the storage device to the
server.
Step 2. Turn on or restart the server. Before the operating system starts up, repeatedly press and release
F12
until Startup Device Menu is displayed.
Step 3. Select the desired storage device and press
Enter
. The server will start up from the selected
device.
Exiting the Setup Utility program
Follow this procedure to exit the Setup Utility program.
To exiting the Setup Utility program, do one the following steps:
• To save the new settings, press
F10
; then, select
Yes
in the displayed window, and press
Enter
.
• If you do not want to save the new settings, select
Exit
➙
Discard Changes and Exit
and press
Enter
;
then, select
Yes
in the displayed window, and press
Enter
.
Memory configuration
Memory performance depends on several variables, such as memory mode, memory speed, memory ranks,
memory population and processor.
Chapter 4
.
System configuration
105