Lenovo 7D8J, Руководство по установке, Страница: 107 / 122

Step 5. To save settings and exit the Setup Utility program, press
F10
; then, select
Yes
in the displayed
window, and press
Enter
.
Configuration change detection
With configuration-change detection enabled, an error message is displayed in POST when configuration
changes of some hardware devices (such as storage drives or memory modules) are detected.
To enable or disable the configuration change detection, complete the following steps:
Step 1. Start the Setup Utility program, see “Starting the Setup Utility program” on page 101.
Step 2. Select
Security
➙
Configuration Change Detection
and press
Enter
.
Step 3. Select the desired option, and press
Enter
.
Step 4. To save settings and exit the Setup Utility program, press
F10
; then, select
Yes
in the displayed
window, and press
Enter
.
To bypass the error message and log in to the operating system, do one of the following:
• Press
F2
.
• Start and exit the Setup Utility program , see “Starting the Setup Utility program” on page 101 and “Exiting
the Setup Utility program” on page 105.
Using passwords
Passwords can be set to prevent unauthorized access to the server.
Despite passwords enhance data security, they are not required. Read the following topics if you decide to
set any passwords.
To start the Setup Utility program, complete the following steps:
Password Types
The following types of passwords are available in the Setup Utility program:
• Power-on password
When a power-on password is set, you are prompted to enter a valid password each time the server is
turned on. The server cannot be used until the valid password is entered.
• Administrator password
Setting an administrator password deters unauthorized users from changing configuration settings. If you
are responsible for maintaining the configuration settings of several servers, you might want to set an
administrator password.
When an administrator password is set, you are prompted to enter a valid password each time you try to
access the Setup Utility program. The Setup Utility program cannot be accessed until a valid password is
entered.
If both the power-on password and administrator password are set, you can enter either password.
However, you must use your administrator password to change any configuration settings.
• Hard disk password
Setting a hard disk password prevents unauthorized access to the data on the internal storage drive (such
as a hard disk drive). When a hard disk password is set, you are prompted to enter a valid password each
time you try to access the storage drive.
Chapter 4
.
System configuration
103