Lenovo 7D2F, Руководство по обслуживанию

Страница: 61 / 188

Install a drive backplane
Use this procedure to install a drive backplane.
Before installing a drive backplane:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 49 ).
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
3.
Watch the procedure
A video of this procedure is available at YouTube: https://www.youtube.com/playlist?list=
PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE .
To install a drive backplane, complete the following steps:
Step 1. Align the tabs on the bottom of the drive backplane with the slots on the system board, and insert
them into the slots.
Step 2. Push the top of the drive backplane toward the front of the server until it clicks in place.
Figure 39. Drive backplane installation
After installing the drive backplane, complete the following steps:
1. Connect the cables to the drive backplane.
2. Install the drives (see
“Install a 2.5-inch hot-swap drive” on page 54 ).
3. Reinstall the top cover (see “Install the top cover” on page 134 ).
4. Reconnect the power cords and any cables that you removed.
5. Install the server in the rack.
6. Power on the server and any peripheral devices.
Remove a 2.5-inch hot-swap drive
Use this procedure to remove a 2.5-inch hot-swap drive.
Before removing a 2.5-inch hot-swap drive:
Chapter 3
.
Hardware replacement procedures
53