Lenovo 7515L2U, Руководство по техническому обслуживанию аппаратной части

Страница: 143 / 292

5. Disconnect the signal cable and the power cable from the hard disk drive.
6.
Remove the old hard disk drive from the bracket by flexing the sides of the
bracket enough to slide it free from the hard disk drive.
7.
To install a new hard disk drive into the bracket, flex the bracket and align
pin
1
, pin
2
, pin
3
, and pin
4
on the bracket with the holes in the
hard disk drive.
Important: Do not touch the circuit board on the bottom of the hard disk
drive.
8. Connect the signal cable and the power cable to the new hard disk drive.
9. Install the new hard disk drive and bracket into the rear retainer and rotate
down until the two clips on the blue handle of the hard disk drive bracket
snap into position.
10. Go to “Completing the FRU replacement” on page 155.
Replacing the optical drive
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the
ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the optical drive.
To replace the optical drive:
1. Open the computer cover. See “Opening the computer cover” on page 126.
2.
Pivot the drive bay assembly upward to gain access to the optical drive. See
“Accessing the system board components and drives” on page 127.
Figure 53. Removing the hard disk drive from the bracket
Chapter 9. Replacing FRUs - 607
137