Lenovo 643815U, Руководство по установке

Страница: 36 / 90

a. Disconnect the existing SAS/SATA controller signal cable from the hard
disk drive backplane and from the controller; then, remove the cable from
the server.
b. Route the ServeRAID-MR10i signal cable as shown in the following
illustration and connect it to the hard disk drive backplane.
1
ServeRAID controller
3
J9
2
Hard disc drive backplane
4
J8
If you have other devices to install, do so now. Otherwise, go to “Completing the
installation.”
Completing the installation
To complete the installation, complete the following steps:
1. Install the cover. See “Installing the cover” on page 23 for more information.
2. Install the server in the rack cabinet. See the Rack Installation Instructions that
come with the server for detailed information about how to install the server in a
rack cabinet.
Attention:
v Install the server only in a rack cabinet that has perforated doors.
v
Do not leave open space above or below an installed server in your rack
cabinet. To help prevent damage to server components, always install a filler
panel to cover the open space and to help ensure proper air circulation. See
the documentation that comes with the rack cabinet for more information.
3. Connect the cables and power cords. See “Connecting the cables” on page 23
for more information.
4. Update the server configuration. See “Updating the server configuration” on
page 24 for more information.
22
ThinkServer RS110 Types 6435, 6436, 6437, and 6438: Installation Guide