Lenovo 20WJ001HGE, Руководство по техническому обслуживанию аппаратной части

Страница: 55 / 64

“Remove the golden mylar” on page 34
“Remove the USB board mylar” on page 34
Step 1. Peel off the tape and then disconnect the EDP cable from the system board.
Figure 38. Peel off the tape and disconnect the EDP cable from the system board
Step 2. Disconnect the cable from the system board and release the cable from the cable guide.
Figure 39. Disconnect the two cables and release the cable from the cable guide
Step 3. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove six screws and then remove the LCD module.
Note: The LCD module is an FRU, not disassemble it.
Chapter 4
.
Removing a FRU or CRU
49