Lenovo 1141BUU, Руководство по техническому обслуживанию аппаратной части

Страница: 50 / 126

Numeric error codes
Table 3. Numeric error codes
Symptom or error (beeps, if any) FRU or action, in sequence
0187
EAIA data access error-The access to EEPROM is failed.
(two short beeps)
System board.
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
(two short beeps)
System board.
0190
Critical low-battery error
(two short beeps)
1. Charge the battery pack.
2. Battery pack.
0191
System Security—Invalid Remote Change requested.
1. Run ThinkPad Setup, and then save current
setting by pressing F10.
2. System board.
0251
System CMOS checksum bad— Default configuration
used.
(two short beeps)
1. Charge the backup battery for more than 8 hours
by connecting the ac power adapter.
2. Replace the backup battery and run ThinkPad Setup
to reset the time and date.
0271
Date and time error—Neither the date nor the time is set
in the computer.
(two short beeps)
Run ThinkPad Setup to reset the time and date.
1802
Unauthorized network card is plugged in—Turn off and
remove the miniPCI network card.
(two short beeps)
1. Remove the Mini PCI network card.
2. System board.
Error messages
Table 4. Error messages
Symptom or error (beeps, if any) FRU or action, in sequence
Fan error.
(four short beeps, one long beep) 1. Fan .
2. Thermal grease.
3. System board.
No-beep symptoms
Table 5. No-beep symptoms
Symptom or error FRU or action, in sequence
No beep, power-on indicator on, LCD blank, and no
POST. 1. Make sure that every connector is connected
tightly and correctly
.
2. DIMM.
3. System board.
No beep, power-on indicator on, and LCD blank during
POST. 1. Reseat DIMM .
2. System board.
The power-on password prompt appears. A power-on password or a supervisor password is set.
Type the password and press
Enter .
The hard-disk password prompt appears. A hard-disk password is set. Type the password and
press
Enter .
44
Hardware Maintenance Manual