Lenovo 10K9, Руководство по техническому обслуживанию аппаратной части, Страница: 113 / 158

1. Install the 2.5-inch storage drive into the storage converter. Then, install the four screws to secure the
2.5-inch storage drive to the storage converter.
Figure 27. Installing the 2.5-inch storage drive into the storage converter
2. Connect the signal cable and the power cable to the 2.5-inch storage drive.
3. Install the 2.5-inch storage drive into the storage drive bay. See “Replacing the 3.5-inch storage drive”
on page 105.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 126.
Replacing the 3.5-inch storage drive
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
This section provides instructions on how to replace the 3.5-inch storage drive.
Note: This section also applies to computer models with a 2.5-inch storage drive.
To replace the 3.5-inch storage drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 90.
3. Locate the 3.5-inch storage drive. See “Computer components” on page 31.
4. Disconnect the signal cable and the power cable from the 3.5-inch storage drive.
Chapter 9
.
Installing or replacing hardware
105