Page 13
XP16
LOUVERED PANEL REMOVAL
Remove the louvered panels as follows:
1
.
Remove two screws, allowing the panel to swing open
slightly.
2
.
Hold the panel firmly throughout this procedure. Rotate bot-
tom corner of panel away from hinged corner post until low-
er three tabs clear the slots as illustrated in
detail B.
3
.
Move panel down until lip of upper tab clears the top slot in
corner post as illustrated in
detail A
.
LOUVERED PANEL INSTALLATION
Position the panel almost parallel with the unit as illustrated
in
detail D
with the screw side as close to the unit as pos-
sible. Then, in a continuous motion:
1
. Slightly rotate and guide the lip of top tab inward as il-
lustrated in
detail A
and
C
; then upward into the top
slot of the hinge corner post.
2
. Rotate panel to vertical to fully engage all tabs.
3
. Holding the panel’s hinged side firmly in place, close
the right−hand side of the panel, aligning the screw
holes.
4
. When panel is correctly positioned and aligned, insert
the screws and tighten
.
DETAIL A
DETAIL B
ROTATE IN THIS DIRECTION;
THEN DOWN TO REMOVE
PANEL
SCREW
HOLES
LIP
IMPORTANT! DO NOT ALLOW PANELS TO HANG ON UNIT BY TOP TAB. TAB IS FOR
ALIGNMENT AND NOT DESIGNED TO SUPPORT WEIGHT OF PANEL.
PANEL SHOWN SLIGHTLY ROTATED TO ALLOW TOP TAB TO EXIT (OR
ENTER) TOP SLOT FOR REMOVING (OR INSTALLING) PANEL.
MAINTAIN MINIMUM PANEL ANGLE (AS CLOSE TO PARALLEL WITH THE UNIT
AS POSSIBLE) WHILE INSTALLING PANEL.
PREFERRED ANGLE
FOR INSTALLATION
ANGLE MAY BE TOO
EXTREME
HOLD DOOR FIRMLY TO THE HINGED
SIDE TO MAINTAIN
FULLY−ENGAGED TABS
Detail C
Figure 7. Removing and Installing Panels
