background image

Page 3

 

WARNING

Electric shock hazard. Can cause
injury or death. Before attempting to
perform any service or maintenance,
turn the electrical power to unit OFF at
disconnect switch(es). Unit may have
multiple power supplies.

 

WARNING

Danger of electrical shock, explosion
and fire. Improper servicing could
result in dangerous operation, serious
injury, death or property damage.

 

WARNING

Do not use this furnace if any part has been under
water. A flood−damaged furnace is extremely dan-
gerous. Attempts to use the furnace can result in
fire or explosion. A qualified service agency
should be contacted to inspect the furnace and to
replace all gas controls, control system parts,
electrical parts that have been wet or the furnace
if deemed necessary.

 

WARNING

Danger of explosion. Can cause injury
or product or property damage. Should
the gas supply fail to shut off or if
overheating occurs, shut off the gas
valve to the furnace before shutting off
the electrical supply.

WARNING

SMOKE POTENTIAL

The heat exchanger in this unit could be a source of
smoke on initial firing. Take precautions with re-
spect to building occupants and property. Vent ini-
tial supply air outside when possible.

Unit Operation

FOR YOUR SAFETY READ BEFORE LIGHTING

BEFORE LIGHTING

 smell all around the furnace area for

gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.

Use only your hand to push in or turn the gas control knob.

Never use tools. If the knob will not push in or turn by

hand, do not try to repair it, call a qualified service

technician. Force or attempted repair may result in a fire

or explosion.

The unit is equipped with an automatic spark ignition

system. There is no pilot. In case of a safety shutdown,

move thermostat switch to 

OFF

 and return the thermostat

switch to 

HEAT

. Electromechanical thermostat is shown

in figure 1. For units with electronic temperature controls,

shut off the main disconnect and then turn it on to reset the

ignition control.

THERMOSTAT

FIGURE 1

HEAT

COOL

FAN

50

60 70

80

10

15

20 2530

HEAT OFF COOL

AUTO

ON

A−Placing Unit In Operation

 

WARNING

Danger of explosion and fire. Can cause
injury or product or property damage.
You must follow these instructions
exactly.

Gas Valve Operation for Honeywell VR8305Q (figure 2)

HONEYWELL VR8305Q SERIES GAS VALVE

Gas valve knob is shown in 

OFF

 position.

FIGURE 2

LOW FIRE

ADJUSTMENT

HIGH FIRE

ADJUSTMENT

INLET

PRESSURE

TAP

MANIFOLD

PRESSURE

TAP

Содержание SGA036









Отзывы: