5
Wireless Remote Controller Button Functions
1
3
2
4
5
7
6
10
11
13
9
12
8
1. ON/OFF Button
Turns system on and off
2. UP/DOWN Buttons
Increase or decrease the indoor temperature in one degree
increments (maximum 86°F, minimum 60°F)
NOTE:
Temperature cannot be adjusted in FAN mode.
NOTE:
Press and hold both buttons for three seconds to
alternate the temperature display between the °C
and °F scale.
3. SET Button
Scrolls through unit operations in this order:
• Sleep
• Follow Me
The selected symbol will flash on the display area, press
the
OK
button to confirm.
4. FAN Button
Cycles fan speeds in the following order:
AUTO - 20% - 40% - 60% - 80% - 100%
NOTE:
Holding Fan button down for 2 seconds will activate
Silence feature.
5. TURBO Button
Enables the unit to reach the preset temperature during
cooling or heating operation in the shortest time
6. MODE Button
• Select system operation modes
• Press button to cycle through each setting as follows:
AUTO
>
COOL
>
DRY
>
HEAT
>
FAN
.
NOTE:
HEAT setting is only available on heat pump models.
7. ECO / GEAR Button
Controls temperature/energy efficiency of the unit
NOTE:
Only available in cooling mode.
ECO Operation
• Sets unit to 75°F unit operation if setpoint is lower
• Sets fan to Auto operation if setpoint is over 75°F
NOTE:
If setpoint is manually changed to less than 75°F,
ECO operation is canceled.
GEAR Operation
Reduces electrical consumption to 75% or 50%
8. OK Button
Confirms selected function
9. TIMER Button
a. Initiates an auto-on or auto-off time sequence
b. Press
TIMER
button to initiate the ON time sequence
c. Press the
UP / DOWN
buttons multiple times to set
the desired time to turn on the unit
d. Press
TIMER
button to initiate the off time sequence.
e. To cancel, set timer to 0.0 or turn remote off and on.
NOTE:
Each press of the button increases or decreases
the time (depending on function) in 30 minute
increments up to 10 hours.
Above 10 hours each press of the button will
increase or decrease the auto-timed setting by 60
minutes up to 24 hours.
10. SWING Button
Used to stop or start louver auto swing feature.
11. Breeze Away Button
This feature avoids direct air flow
blowing on the body.
NOTE:
This feature is available under Cool, Fan and Dry
modes only
12. Clean Button
Used to start/stop the Active Clean function
13. LED Button
Turns the LCD display back-light on the indoor unit on or off
NOTE:
Press and hold the button for five seconds to display
the actual room temperature. Press more than five
seconds to revert back to display set temperature.