background image

Page 7

11 -  Inspect the furnace return air duct connection to 

ensure the duct is sealed to the furnace. Check for 

air leaks on supply and return ducts and seal where 

necessary.

12 -  Check the condition of the furnace cabinet insulation 

and repair if necessary.

13 -  Perform a complete combustion analysis during the 

furnace inspection to ensure proper combustion 

and operation. Consult Service Literature for proper 

combustion values.

14 -  

Verify operation of CO detectors and replace 

batteries as required.

Perform a general system test. Turn on the furnace to 

check operating functions such as the start-up and shut-

off operation.

1 -   Check the operation of the ignition system, inspect 

and clean flame sensor. Check microamps before 

and after. Check controls and safety devices (gas 

valve,  flame  sensor,  temperature  limits).  Consult 

Service Manual for proper operating range. Thermal 

Limits should be checked by restricting airflow and 

not disconnecting the indoor blower. For additional 

details, please see Service and Application Note 

H049.

2 -   Verify that system total static pressure and airflow 

settings are within specific operating parameters.

3 -   Clock gas meter to ensure that the unit is operating 

at  the  specified  firing  rate  for  each  stage  of 

operation. Check the supply pressure and the 

manifold pressure on both low fire and high fire. If 

manifold pressure adjustment is necessary, consult 

the  Service  Literature  for  unit  specific  information 

on adjusting gas pressure. Not all gas valves are 

adjustable. Verify correct temperature rise.

 WARNING

This prodcut contains a chemical known to the State 

of California to cause cancer, birth defects, or other 

reproductive harm.

Repair Parts List

The following repair parts are available through Lennox 

dealers. When ordering parts, include the complete fur-

nace model number listed on the CSA International name-

plate -- Example: EL195DFE045P36B. All service must be 

done by a licensed professional installer (or equivalent), a 

service agency, or the gas supplier.

Cabinet Parts

Upper access panel
Blower access panel
Top Cap

Control Panel Part

s

Transformer
Integrated control
Door interlock switch

Blower Parts

Blower wheel
Motor
Motor mounting frame
Motor capacitor
Blower housing cutoff plate

Heating Parts

Flame Sensor
Heat exchanger assembly
Gas manifold
Combustion air inducer
Gas valve
Main burner cluster
Main burner orifices
Pressure switch
Ignitor
Primary limit control
Flame rollout switches

Содержание EL195E








Отзывы: