20
Repeater (21L09)
Repeater – 24VAC Line Power
The wireless repeater can only be powered by an
external 24VAC power source.
Repeater – Wireless Installation Setup
NOTE:
Wireless Repeaters are only compatible
with the CORE (M4) Unit Controller.
IMPORTANT
It is recommended to add the repeaters
after adding the wireless sensors. It is highly
recommended adding the repeaters at the roof-
top unit before installation in desired locations.
To join the wireless repeater to the rooftop unit BLE
mesh network, the following is required.
Using the CORE Service App, and go to the
RTU
Menu
>
Network Integration
>
Wireless
Sensor
Network Setup
>
Wireless Sensor Network
>
Provision
Sensor Network
>
Network Nodes
.
1. Click
Add Node
on the Network Nodes
screen. This triggers the CORE Service App
to scan Bluetooth Low Energy (BLE) mesh
beaconing.
2. Press and hold the
Beacon
button on the
wireless repeater for two seconds.
3. The user should be able to see the MAC ad-
dress of wireless repeater on the CORE Ser-
vice app.
NOTE:
The wireless repeater MAC address can
be verified with the label on the repeater.
4. Verify the CORE Service app displays the
“Node Added” on the
Sensor Network
.
RESET button
BEACON enable button
CAPTIVE screw
SIGNAL strength LED
Figure 7. Wireless Repeater Buttons,
Indicators and Terminals