NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE
1
These bi-fold glass door assemblies have been designed for use with and
may be easily fitted to your Lennox Outdoor Gas Fireplace, Models
E36ODG & E42ODG.
Do not alter or modify these door assemblies or a fireplace malfunction
or a fire hazard may result.
These doors have been tested and listed by Omni-Test Laboratories
Inc.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
GENERAL INFORMATION
The door assembly consists of a right and left glass panel assembly with the
door handles factory mounted. Included is a four piece door frame with
eight (8) screws and a hood (hood packaged separately), which are required
for assembly. Fireplaces listed on the front page of this document, have
been designed to accept these doors with minimum effort.
TOOLS REQUIRED
• Medium Phillips Screwdriver •
3/8" Open-end wrench
• 1/4" Drive Socket
FIREPLACE KITS
AND ACCESSORIES
INSTALLATION INSTRUCTIONS FOR OUTDOOR BI-FOLD GLASS DOORS
MODELS: 36BFOD-BS & 42BFOD-BS
BI-FOLD GLASS DOORS
750,210M
Rev. A 07/2006
INSTALLATION INSTRUCTIONS
Remove Screens And Rods:
Using a 5/16" socket or nutdriver, remove the screen rod assemblies
(see
Figure 1 ). Remove the screen rod screws as shown in Figure 1.
Pull out the rods from locating holes on the side of the firebox opening.
IMPORTANT! REINSTALL SCREEN ROD SCREWS INTO THE EXISTING
HOLES WHERE REMOVED.
The screen and rod assemblies must not be installed when the Bi-Fold
Glass Door Kit is installed. You may wish to retain the screen and rod
assemblies is case the Bi-Fold Glass Door Kit is ever removed in the future.
IMPORTANT! IF THIS OPTIONAL BI-FOLD GLASS DOOR KIT IS EVER
REMOVED, THE ROD AND SCREENS MUST BE REINSTALLED FOR
SAFE OPERATION OF THE APPLIANCE.
Screen Rod
Screws
Screen And
Rod Assembly
Figure 1
