Lenel LNL-200XAU, Быстрая справка

Страница: 3 / 4

3 DOC-1135-EN-US— revision 1.001
Connections
Maintenance
This unit is intended for use by Service Personnel only. There are NO USER
SERVICEABLE parts inside.
There is no regular maintenance required of the LNL-200XAU other than
periodic testing and replacement of the standby battery. Reference should be
made to the battery manufacturer's documentation to determine typical/
expected battery life with a view to periodic replacement of the battery.
Disposal of Product at End of Life
This product falls within the scope of EU Directives 2012/19/EU Waste
Electrical and Electronic Equipment (WEEE) and 2013/56/EU (Battery). At
the end of life, the product must be separated from the domestic waste
stream and disposed via an appropriate approved WEEE disposal route in
accordance with all national and local regulations.
Before disposal of the product, any batteries must be removed, and disposed
separately via an appropriate approved battery disposal route in accordance
with all national and local regulations. Package used batteries safely for
onward transport to your supplier, collection point or disposal facility.
See Specifications for battery type information. The battery is marked with
the crossed out wheelie bin symbol, which may include lettering to indicate
cadmium (Cd), lead (Pb), or mercury (Hg). For more information, see
www.recyclethis.info .
Note: Risk of fire or explosion if bare battery wires are allowed to
touch.
Compliance
This power supply unit meets the essential requirements of the following
European Directives:
• Low Voltage 2014/35/EU
• EMC 2014/30/EU
• WEEE 2012/19/EU
• RoHs2 2011/65/EU
Explanation of Symbols
Not all may apply.
Product Warnings and Disclaimers
THESE PRODUCTS ARE INTENDED FOR SALE TO AND
INSTALLATION BY QUALIFIED PROFESSIONALS. UTC FIRE &
SECURITY CANNOT PROVIDE ANY ASSURANCE THAT ANY
PERSON OR ENTITY BUYING ITS PRODUCTS, INCLUDING ANY
"AUTHORIZED DEALER" OR "AUTHORIZED RESELLER", IS
PROPERLY TRAINED OR EXPERIENCED TO CORRECTLY INSTALL
FIRE AND SECURITY RELATED PRODUCTS.
For more information on product warnings, refer to
https://www.firesecurityproducts.com/policy/product-warning/ or scan the
following code:
PoE IN PoE 802.3bt (60 W) from PoE++ source
Note: PoE and PoE+ can be used. See output
specifications.
DATA Data connection to IP device
OP +/- Load output: 13.8 VDC (+/- 5%) at 3 A max
(PoE++ input)
BATT +/- 12 V battery connection - observe polarity
PoE Relay output for PoE power failure. Open on loss
of PoE.
GEN Relay output for output fuse failed or/and low
battery level (less than 10.7 VDC) when PoE is off.
Open in fault condition.
Fault indication
Mains present
Protective earth
Shock risk - Isolate before attempting access
Certification level
Do not dispose of in unsorted waste