Lencore MPI-2 LOCAL, Руководство пользователя

Страница: 17 / 20

Operation
Plug the power cable into the MPI-2. The Power LED will be on and solid while
the Status LED will blink for approximately 10 seconds. When the Status LED
stays off, the MPI-2 is ready to use.
Phone Paging:
1.
Plug the analog phone line (RJ11) into the MPI-2 Phone input.
2.
Dial the extension of the phone line. The Status LED will turn on.
3.
Wait for a tone from the MPI then press 00# for an all-call page or the
zone number followed by the “#”. Pressing the “*” will
hang-
up after
pressing the “#.”
4.
Wait for a tone from the MPI then make the page. Hang up the phone
receiver when the page is complete. The Status LED will turn off.
Note: The zones must be configured with Lencore’s System Manager or Reports
software.
The telephone input requires a POTS appearance line using an RJ11 connector.
The basic specification for a POTS appearance line is below:
A CO (central office) POTS line is a 2-wire analog appearance.
1) It is a 2 wire (Tip and Ring) analog appearance.
2) It is configured to be loop start.
3) Battery voltage is 48 Volts.
4) Loop current of 23 milliamps.
5) Must have DTMF signaling capability.
6) Must have hang-up (winking) supervision.
Generally, the use of an FXS card (Foreign Exchange Station) or an ATA card
(Analog Telephone Adapter) is required not an FXO (foreign exchange office)
card.
Assign an extension to the port. Calling the extension will activate the paging
system.
MIC Paging:
Direct MIC connection
1. Connect a microphone to the MIC input.
2. Press the MIC key to make a page.
14