9
INSTALLING THE BATTERIES FOR CLOCK/FM PRESET CHANNEL/TIMER BACKUP
The clock/FM preset channel/timer (if set) will be maintained during a power failure by installing 2 x AAA/LR03 batteries (not
supplied). Once the power is restored, check the clock to make sure it is accurate and set it again if necessary.
INSTALLING THE BATTERIES
1.
Open the battery compartment at the bottom of the unit by pressing on the catch and removing the cover.
2.
Insert 2 x AAA/LR03 batteries (not supplied), preferably alkaline batteries, into the battery compartment following the polarity as
shown on the diagram inside the compartment.
3.
Replace the battery compartment cover.
CONNECTING TO THE POWER SUPPLY
Plug the AC power cable into the AC wall socket.
BASIC OPERATION
Press the STANDBY button to turn on the unit. To turn off, press and hold the STANDBY button again.
Alternatively press the STANDBY button on the remote control to turn on or turn off the unit.
FM/BT
When the unit is turned on, press the SOURCE button to toggle between FM and Bluetooth mode.
Volume Control
Press the /
-
buttons to change the volume.
Adjusting the Antenna
The antenna wire at the rear panel of the unit should be fully extended to ensure a good FM reception. Alter the antenna position for
the best reception.
FM RADIO OPERATION
Auto Scan
1.
Turn on the unit in FM mode.
Press and hold the SCAN button on the unit (or press the SCAN button on the remote control) to start auto
-
scanning and saving the
available channels (Max. 20 stations can be stored)
Manual Scan
1.
Press the
or
button on the unit (the TUNE
/TUNE
button on the remote control) repeatedly to tune to a different
frequency.
2.
Press and hold the
or
button on the unit (the TUNE
/TUNE
button on the remote control) to automatically
search to the next available channel.
Storing FM Presets
You can save up to 20 FM presets.
1.
Tune to the station you wish to store.
2.
Press and hold the MEMORY button on the unit (or press the MEMORY button on the remote control). Flashing preset channel
number is displayed.
3.
Press the
or
button on the unit (the
or
button on the remote control) to a preset number that you want to
store. Then press the MEMORY button to save.
