2
To remove the protective cap, rotate the accessory release at the side of the unit,
near the front.
2. Screw the modelling lamp in to the lamp holder.
3.
Plug into the mains and switch on. Both the switch and the illuminated back panel will
light up to indicate that the unit is ready for use.
The control panel
There are just 2 control buttons, cell and model. Press the ‘model’ button to switch the
modelling lamp either on or off.
Press the ‘cell’ button to switch the photo-electric sensor on or off. When it is switched on, the
flash sensor will ‘see’ the flash from another flash unit and will fire instantaneously. Each
button is illuminated when switched to the ‘on’ position.
The flash sensor is located on the top of the flash unit and must be left uncovered. Flash
sensors work by detecting a sudden increase in the level of light – the flash from another flash
