Lemo MEERKAT HD, Инструкция по эксплуатации, Страница: 6 / 12

6
www.lemo.com
Option 1 - Remote Camera Power
With the Remote Camera Power setup, the camera
is powered directly through the SMPTE-311M
cable. The useable cable length of the SMPTE -
311M cables is limited by the resistance of the
copper power conductors and will vary between
cables from different cable manufacturers. However
distances of up to 2 km are achievable.
Triax connector.
Connect the Triax connector (provided with 1 metre
cable lead) to the appropriate socket located on the
Triax camera or the OB van. Connect Unit A to the
camera and Unit B to the OB van/CCU.
HDTV connectors.
Connect the HDTV connector (LEMO 3K.93C
Series) to the appropriate HDTV compatible socket
or plug. Note: as with HDTV systems ensure that
the HDTV (SMPTE) cable is laid in the appropriate
direction - socket at the OB van / CCU end and plug
at camera end.
MEERKAT Power Supply.
Connect the unit to a suitable power source by
using either the AC/DC adaptor (12Volts) supplied
or the battery belt / power pack that is available as
an optional accessory (common battery pack manu -
facturers).
On/Off power switch
Press the power button to turn the power on, the
power LED will illuminate. The camera picture
should stabilise and all the green LEDs should be
illu minated, if not see chapter on troubleshooting
(page 8). Pressing the power button again will turn
the power off.
Operating Instructions - Remote Camera Power
Remote Camera Power
(SMPTE 311M cable)
2 km - SMPTE 311M cable
1m - TRIAX
12 V - 1.5 A max
1m - TRIAX
Local 12 V source (1.5 A max)
MEERKAT ™
(A)
MEERKAT ™
(B)