LEMAN MOR375, Инструкция по сборке и эксплуатации

Страница: 47 / 56

MS3816 Hollow Chisel Mortiser
V.03 01-03-2008
５
understood, or if in doubt as to whether the tool is properly grounded.
Use only 3-wire extension cords that have grounding type plugs and receptacles that accept the tool’s plug.
Repair or replace damaged or worn cord immediately.
WARNING: IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN QUESTION IS PROPERLY
GROUNDED. IF YOU ARE NOT SURE, HAVE A QUALIFIED ELECTRICIAN CHECK THE RECEPTACLE
.
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension
cord, which has a grounding type plug and a receptacle, which will accept the tool’s plug. When using an
extension cord, be sure to use one heavy enough to carry the current of the tool. An undersized cord will
cause a drop in line voltage, resulting in loss of power and overheating.
OPERATING INSTRUCTIONS
FOREWORD
Fox Model F14-652 is easier to operate than a conventional drill press equipped with a mortising
attachment. The model F14-652 is made of cast-iron and steel for rigidity and stability. The mortiser
comes with a standard 3-jaw type key chuck for positive gripping of mortising bits.
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping carton(s). Remove the protective
coating from all unpainted surfaces. This coating may be removed with a soft cloth moistened with
kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the
unpainted surfaces with a good quality household floor paste wax.
NOTICE: THE MANUAL COVER PHOTO ILLUSTRATES THE CURRENT
PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS ARE REPRESENTATIVE
ONLY AND MAY NOT DEPICT THE ACTUAL COLOR, LABELING OR
ACCESSORIES AND MAY BE INTENDED TO ILLUSTRATE TECHNIQUE ONLY.
EN