TO INSTALL ATTACHMENT TO MOTOR:
1. Align the drive of the motor with the hub (#9) and drive shaft (#11C) of the
slicer/tenderizer attachment and tighten the star bolt (on motor) securely.
2. Insert the two meat combs (#1) into the slots in the top of the upper housing (#3) – one comb on
each side of the upper case. The combs should slide easily into the holes between the drive and
driven shafts. When inserted properly, the combs will be visible from the bottom of the lower
case (#8).
OPERATING INSTRUCTIONS OF ATTACHMENT UNIT:
Read these instructions before operating jerky slicer/tenderizer attachment.
1. Drop meat through the opening of the cover. DO NOT attempt to force meat into the opening.
Rolling action of the knives will carry appropriately sized portions of meat into the unit.
2. Use boneless cuts of meat only. Meat should not exceed 1 1/4” thickness. Remove gristle and
bone before tenderizing/slicing to eliminate clogging or stalling.
3. For tenderizer attachment: run meat through tenderizer twice at a 90 degree angle to experience
the maximum tenderness.
433TJ - 8
1
CASE-LOWER
433TJ - 3
1
CASE-UPPER
433TJ - 9
1
HUB
433TJ - 4A
1
Driven Shaft Assy
(SLICER)
433TJ - 13A
1
DRIVE SHAFT
Assembly
433TJ - 10
2
HUB SCREW
433TJ - 2
2
THUMB SCREW
433TJ - 1
2
COMB
433TJ - 4
2
DRIVEN SHAFT
433TJ - 5
6
BUSHING, NYLON
433TJ - 17
15
KNIFE-SLICER
433TJ - 18
6
SS WASHER
433TJ - 15
6
LOCK RING, (C-Clip)
433TJ - 16
6
E RETAINER RING
433TJ - 13
1
DRIVE SHAFT
433TJ - 11C
1
DRIVE SHAFT ADAPTER
433TJ - 14
3
GEAR
433TJ - 7
93
SPACERS
433TJ - 6
30
KNIFE TENDERIZER
433TJ - 12
1
SET SCREW
Part #
Qty
Description
433TJ Parts List
433TJ - 4B
1
Driven Shaft Assy
(TENDERIZER)
CIRCUIT BREAKER INFORMATION:
Your LEM motor is equipped with a circuit breaker to protect the unit. In the event of a power
disruption, abnormal operation or over heating, the motor will temporarily shut down to prevent
damage. If this should happen, follow the seven steps listed below:
Step 1: Turn On/Off switch to off.
Step 2: Unplug unit.
Step 3: Check inside of unit and remove any obstruction.
Step 4: Wait 1 or 2 minutes, then plug unit into wall outlet again.
Step 5: Push Restart Button and release. Located on back panel of motor.
Step 6: Turn switch on.
Step 7: Resume Operation.
LEM Products • 109 May Drive, Harrison, OH 45030 • PH: 877-536-7763 • www.lemproducts.com
LEM Products • 109 May Drive, Harrison, OH 45030 • PH: 877-536-7763 • www.lemproducts.com
