LELY SPLENDIMO 280 MC, Руководство оператора

Страница: 16 / 33

E-14
- If the machine needs to be placed in the transport position at the
end of its operation: wait until all moving parts have come to a
standstill.
When folding up a machine with rotating parts, serious
damage may be incurred by the PTO shaft.
Please also be referred to chapter 3 “Transport”.
- If the machine does not follow the ground contours effectively, or
if it tends to dig into the ground, the machines ground pressure
should be adjusted (see § 4.3).
Closing the crop inlet plate increases the speed of the crop allowing
the swath boards to control swath more effec- tively (narrower).
Should the machine hit an obstacle during mowing, it can move
backward thanks to the extension of the breakback device (fig. 15).
After extension of the breakback device: drive backwards a few
meters until the breakback device has locked back into position.
The machine is protected against overload by a slip clutch.
6 DISMOUNTING FROM THE TRACTOR
- Lower the machine.
- Set the parking jacks in the lowest position.
SPLENDIMO MC mower with mechanical ground pressure relief:
- Raise the machine with the lifting device of the tractor and the
hydraulic valve in the floating position until the retaining pin can
be placed in the sliding frame in front of the springs (fig. 16).
- Lower the three point hitch until the parking jacks are supported
by the ground.
- Switch off the tractor engine. Disengage the PTO shaft from the
tractor PTO.
- Place the PTO shaft in the hook.
SPLENDIMO MC mower with hydraulic ground pressure relief:
- Set the hydraulic tractor valves in the floating position. By
operating the handle that protrudes from the hood (fig. 17) you
can relieve the pressure of the hydraulic system. The pressure
value to be indicated by the gauge should be 0 bar.
Adjust the descending speed at a higher value by means of the
blue turning button in case the pressure does not drop at all, or
only very slowly (attention: this will accelerate the speed of
descending during operations - see § 4.4).
- Remove the control cord for the hydraulic system from the tractor
cab.
- Disconnect the hydraulic hoses.
- Disengage the top link from the machine.
- Uncouple the lower arms from the machine.
15
16
17
!