Pag. 4
ENGLISH
COMPONENTS:
1.
Safety cap
2.
Wand seat
3.
Boiler switch
4.
Iron switch
5.
Low water indicator light
6.
Steam regulation knob
7.
Temperature regulation knob
8.
Steam button
9.
Iron plate
10.
Gauge
USER INSTRUCTIONS:
1.
Remove the ironing machine from its packing and make sure all packing parts have been taken off
(including the protection bags). Lay the machine on a flat and steady surface fitted to support it next to a
wall socket (max. mt. 1,5).
2.
Insert in the wand seat (2) the supplied wand to hold the hose up and hook it with the spring up to the
iron-boiler connecting wire.
3.
Unscrew the safety cap (1) and let the internal air out. Fill the boiler with max. 2,0 litres of water, use
the funnel supplied, making sure you do not overfill the tank. Close the safety cap (1).
4.
Insert the plug into an electrical outlet; switch on boiler (3) and iron switch (4). If the two buttons come
on, iron and boiler are working.
5.
Turn the iron plate’s temperature regulating knob (7) to the position “cotton °°°” (indicated on the iron
knob).
6.
Wait that the boiler switch’s red light (3) goes off (it takes about 10 minutes). While ironing, the boiler
switch’s red light (4) normally comes on.
7.
The machine is ready for use.
8.
Push the steam button (8).
9.
It is possible to regulate the quantity of steam by the steam knob (6) – only for the models PS05/B and
PS09/D
10.
In case the steam stops during ironing and the low water light indicator (5) comes on, it means that
there is not enough water in the tank. To start ironing again, switch off the boiler switch (3); press the
steam iron button (8) to ensure there is no more steam in the boiler, slowly open the pressure cap (1),
disconnect the plug and refill to the required level. Fill the boiler with warm water and wait for it to build
up pressure again.
11.
When you first press the steam button (after having turned the boiler on and depressed the steam
button on the iron) you might notice a decrease in pressure. This is because the tank has air in it. In
order to have plenty of steam (after you have depressed the iron) wait until the pressure goes back up to
the maximum level before you begin.
12.
it is possible to check the inner pressure level of the boiler by means of the pressure gauge (10) – only
for the model PS09/D.
CAUTION:
-
Do not leave the machine unattended while the plug is connected to the socket.
-
The iron reaches very high temperatures and it keeps being very hot even 15 minutes after it’s been
switching off. Be careful not to burn yourself.
-
For complete safety, before filling the boiler, please disconnect the plug.
-
While using the machine and 15 afterwards the iron plate (9) has very dangerous temperature – do not
touch it.
-
While using the machine, never unscrew or remove the cap (1) while under pressure. Before removing it,
make sure that it does not give off steam anymore by shutting the boiler off, and pressing the steam iron
button (8) to release all remaining steam.
-
The machine has a special heating element. Only qualified technician should replace it.
-
The safety cap (1) must be replaced with original parts only.
PLEASE NOTE:
The use of normal tap water is recommended. In order to clean the boiler and remove limestone, rinse it
internally (every 15-20 litres of water used or every month) only with tap water.
