Lekla PIVO, Руководство по установке

Страница: 12 / 22

POLE LIFTING PROCEDURE
ANNEX 1
■
■
■
■
■
■
■
■
■
■
■
■
■
Page 1 of 2
Access to the battery storage system is discreet and secure.
Two hydraulic hoses located at the base of the pole are equipped with quick couplings and coupled to one
another.
Access the hoses by removing the cover of the service door located approximately 18 in. from the base of the
pole (Figure 1).
Grasp the end of the hoses with your hand, pull the two quick couplings out of the pole and uncouple them.
Depending on the choice you made when acquiring your PIVO | LEKLA Multi-Purpose Autonomous Energy
Station, connect the two quick couplers on the drum to the portable hydraulic unit.
Place the hydraulic valve in the mounted position and activate the hydraulic unit to allow the center tube to
be lifted into the base.
Once the mechanism is at its maximum height, deactivate the lift valve. The mechanism becomes stationary.
Extend the two orange safety stands so that they rest against the 660 mm (22 in.) cylinder wall (Figures 2
and 3).
When the pole is lifted 450 mm (17.7 in.) off the ground, the control box and the battery storage area can be
accessed.
In order to lower the pole using the portable unit, retract the safety stands and lower the pole to its base.
Once on the base, uncouple the hydraulic connections of the handheld unit from the lifting base and couple
the pair for each piece of equipment to avoid dust contamination.
Reinsert the hoses of the lifting system inside the pole and close the service door cover.
Take care to have a cloth or absorbent fabric to collect any oil drops that may have escaped when uncoupling
the quick couplings.