5
CHAPTER 1
1. Congratulations!
You are the proud owner of a brand new
! When you receive your bike, the first thing to do is
check that it has arrived in perfect condition. Open the top of
the box, and visually inspect the bike.
2.
Remove the bike from the box, be careful, as eBikes are
generally
much heavier
than standard bikes, so some help
maybe needed for this step (you may find it easier to cut the
side of the box open, be careful whilst using sharp knives!).
Once removed, you will find a
small accessory box
, the
charger box
and of course your
bike!
3.
For the correct assembly of your bike you will need the
following tools;
8mm/10mm/15mm spanners,
3/4/5/6mm Allen keys
, a small amount of
lithium grease
and a
pump
.
4. Remove
all the packaging
cut
the cable ties holding the
handlebars in place and proceed to
step 5.
Getting started
MANUAL LEKKER BIKES /
CHAPTER 2
MANUAL LEKKER BIKES /
6
Handlebar fitment &
adjustment
5.
Centre the handlebar and stem and tighten to
14Nm
with a 6mm allen key.
To adjust the angle of the
handlebar, loosen the allen bolts of the front plate until
you can move the handle bar freely, once you have found
your desired bar angle, tighten the bolts to
5Nm
.
6.
Now it’s time to adjust the
angle of the brake levers
and gear shifter
to your desired position. Using a
4mm
Allen key
, loosen the two bolts on each of the brake
levers to allow you to move them, once in the correct
position tighten the bolts to the manufacturer’s torque
recommendation.
PLEASE NOTE:
you may have have to adjust the gear
shifter position to allow you to move the right hand lever,
to do this,
loosen
the bolt with a
3mm allen key
, then
perform the same steps as above,just remember to
tighten the shifter back up!