3.
ASSEMBLY
3.1
Assembly / drilling template for EasyAlarm®
Drilling template
Note:
If EasyAlarm® is mounted in a closed box (i.e. EA-IP-Box
10.10) the internal microphone must be turned off
(to eliminate acoustical feedback). In this case mark dialler to pointing out that the microphone is turned off. Label unit
with “microphone deactivated”.
3.2
Assembly of the sub-communication unit
Once mounted, the speaker and the microphone in particular should not be covered, otherwise the communication
quality decreases (reduced volume, poor hands free quality)
Make sure the microphone hole and the panel hole fit.
The sub-communication unit must be mounted directly behind the panel without any gap, otherwise there will be an
acoustic feedback. If necessary insulate speaker and microphone room acoustically using foam or rubber.
Do not use any foil between the front panel and sub-unit, not even in waterproof versions option: -WG.
3.2.1
Retrofit solutions to existing elevators
3.2.1.1
Chrome panels (flush / surface mount, Inox=steel or PC=polycarbonate
EA-TAB (without button)
EA-TAB-NT
EA-TAB-HK("Help is coming") EA-TABPC-NTI (comm. unit
if current button remains in use incl. ext..button RT-42/Typ IX incl. ext. display RA-42
with integrated emerg. button)
Art. No: 100.0220 Inox 2mm
Art. No: 100.0221 Inox 2mm Art. No: 100.0222 Inox 2mm
Art. No: 100.0210 PC 3mm
Art. No: 100.0211 PC 3mm Art. No: 100.0212 PC 3mm
Art. No: 100.0216 PC 3mm
100 x 200 mm
100 x 200 mm
100 x 200 mm
100 x 200 mm
3.2.1.2
Transparent frame for surface mounting of panels
Suitable for front panels 100.0220 to 100.0223 incl. two inlays on bottom / top for LED emergency light chain e.g. Art. No:
100.0870 or 100.0873
Art. No: 100.0231
Art. No: 100.0232 Seal
100 x 220 x 23 mm
100 x 200 mm (Foam 1.5mm)
incl. two mounting-screws
for panels 100.0220 to 100.0223
5
Sub-comm. unit
Panel
Sub-comm. unit
foam or aligned
Sub-comm. unit
Sub-comm. unit
