9
Program calling number(s)
Details according to section 6.1
6.
Slide function switch to PROG
7.
Enter
* * <n>
(selected calling number: Standard
n
= 1..9)
Corresponding calling number will be announced, followed by message “to modify press star“
8.
Press
*
and enter calling number
9.
Slide
function switch
to OFF
Select user language / record individual message
Details according to section 6.3
10. Slide
function switch
to PROG
11. Enter
*
.
*
.
#
.
Current individual message will be announced followed by “to modify press * , to stop press # “
12. Select language for user announcements: (facultative)
Press key
1
to
4
to select user languages: 1 for German, 2 for French, 3 for English GB, 4 for Italian
13. Press
*
.
and start speaking
14. Press
#
.
to finish recording, max. duration is 12 seconds
New individual message will be announced. You can repeat steps 15 to 16 until text is fine!
15. Slide
function switch
to OFF
Program PIN-code
Details according to section 6.4
16. Slide
function switch
to PROG
17. Press key
#
.
You can prevent the alarm unit from unintended re-programming by pressing *. ..
18. Enter PIN-code (4 to 7 digits)
19. Press key
#
.
20. Re-enter PIN-code for confirmation
21. Press key
#
.
New PIN-code will be announced
22. Slide
function switch
to OFF
Alarm unit is now ready for operation
Details according to section 7
23. Slide selection switch to the requested position (I/II/III)
4.2.3 Test mode for sensor contacts
You can test the wiring as following:
1.
Slide
function switch
to PROG
2.
Enter
*
.
*
.
*
.
*
.
Any time a monitored sensor contact changes to alarm state you will hear the announcement”<n> activated”.
If the contacts changes to idle state you will hear “<n> deactivated.
3.
Slide
function switch
to OFF
Notes:
<n>
= 1/2/3 (depending on sensor)
Only sensors with contact type other than inactive (00) will be announced => see configuration in section 5.