Leitronic AG EasyAlarm BASIC, Инструкция пользователя, Страница: 16 / 32

16
7. OPERATION
7.1 Self check at power on
After power on the alarm unit checks battery, mains power and telephone-line conditions. If one of these tests fails an
appropriate message will be announced (battery error/power failure/line-check error).
Three beep: Mains power loss AND battery low at the same time!
Quickly handle the announce problem, otherwise the alarm functions are not guarantied.
7.1.1 Detection of wired sensor
EasyAlarm
®
detects the connected motion sensor automatically during the switching on procedure (factory setting). This
sensor is activated for presence verification
Important notes:

By disconnecting the motion detector during the operation mode, an alarm is triggered followed by the
announcement: ”alarm due to sensor 1, sensor failure!”

By connecting the motion detector after the start up procedure of the alarm unit, an alarm is triggered followed by
the announcement: “alarm due to sensor 1, sensor 1 activated!”
7.2 Arm / Disarm system
After power on
EasyAlarm
®
automatically arms the system. During operation
EasyAlarm
®
can be armed/disarmed
using the remote control or during any telephone connection using DTMF 7 and 9 .

Announce “supervision activated “ or “supervision deactivated”
7.3 Inactive waiting period
7.3.1 After power on or changing position of selection switch (exit delay)
EasyAlarm
®
remains inactive for 20 seconds (LED is on continuously), to leave time to quit your room/house without
triggering an alarm. An emergency call by pressing the emergency button is still possible.
Note:

The entry/exit period can be adjusted according to section 10.3.

If there are unacknowledged alarms, their quantity and the reason of the last alarm will be announced.

If presence verification is activated, following announcement is made: "Presence verification activated".
Key Action
5 Announcement of the monitored functions ( inactive waiting period will be restarted)
7
Bypass waiting period and change to inactive supervision mode

Attention: by switching from activated to inactivated supervision mode, an announcement of the
supervision modes is made and the waiting period starts again.
9
Bypass waiting period and change to active supervision mode

Attention: by switching from inactivated to activated supervision mode, an announcement of the
supervision mode is made and the waiting period starts again.
others Test-call will be made to the first calling number
7.3.1.1 Announcement of the supervision functions
The supervision functions can be activated or deactivated individually on each position of the selection switch
EasyAlarm
®
deactivated

announcement: "Supervision I/II/III deactivated"
EasyAlarm
®
activated

announcement: "Supervision I/II/III”
followed by the supervision mode of the activated type of monitoring:
acoustical monitoring

announcement: "due to noise"
sensor-1 monitoring

announcement: "due to sensor 1”
sensor-2 monitoring

announcement: "due to sensor 2”
sensor-3 monitoring

announcement: "due to sensor 3” .. “activated”
7.3.2 ..after an successful alarm
EasyAlarm
®
remains inactive for two minutes (LED is on continuously) to avoid too many alarms due to sensor contacts.
An emergency call is still possible during this period. Any key-press results in a test call to the first calling number.