5
3. SET VIEW / FUNCTION ELEMENTS
1
.
Function switch
Position
Information
OFF
Device is switched off
PROG
Entering of calling numbers, calling number sequence, PIN-Code and further parameters
ON
Device is in
supervision mode
2
.
Selection switch
EasyAlarm
®
monitors depending on the position of the selection switch
Position
Monitoring functions (
on position ON)
I
Wired sensor-1 enabled. Acoustical monitoring disabled!
II
Wired sensor-1 enabled. Acoustical monitoring disabled!
III
Wired sensor-1 enabled. Acoustical monitoring enabled with highest sensitivity => Alarm is triggered if
noise level is exceeded two or three times within a short period
Note: Monitoring functions can be modified individually according to section 5.4
ff
!
3
.
Keypad
When
function switch
is on position PROG, you can enter the calling numbers or do further programming. If
function
switch
is on position ON pressing any key will start a
test call.
Keys are marked with
1 2 3 4 5 6 7 8 9 * 0 #
.
in the following sections.
4
.
Loudspeaker
The integrated loudspeaker is used for voice guidance during the programming as well as for hands-free communication
during
phone connection
.
5
.
Microphone
Is used during
hands-free connection
and for recording of
individual message
.
6
.
LED
Status of LED
Operation mode
Green
Waiting period
Green brief flashing every 4 seconds, also if acoustical
monitoring is active by exceed set noise level
Supervision mode activated
Green is on and off for 4 seconds alternatively
Supervision mode deactivated
Orange
Phone connection
7
.
Battery compartment
The 9V-battery is used as a backup during power failure.
Please note: The telephone cord must be disconnected before opening the battery
compartment because otherwise you can get in contact with the telecommunication voltage!
8
.
Telephone jack (
-LINE)
The plug must be locked in the jack. To disconnect press pawl.
9
.
External ports (
EXT/≂)
for accessories (as motion sensor) and power supply.
6
1
5
4
3
2
-L
IN
E
EX
T/
~
7
9
8