Leisure UNITY 2017, Руководство пользователя

Страница: 25 / 130

Unity Motorhome
21
Safety
Malfunction/Service Signal:
If any malfunction is detected, the Gas LED
will remain off and the Operational/CO LED will
alternate red/green and the alarm will sound
once every 15 seconds. Press the Test/Mute
button. If the Test/Mute button does not clear
the signals, check the battery voltage. If the
battery voltage is not low and the unit will not
return to normal operation, immediately remove
the alarm and return for service or warranty
replacement. See the warranty section in this
manual.
OPERATION AUDIBLE
SIGNAL
VISUAL SIGNAL
Normal None Steady Green
C.O. Alarm 4 beeps
5 seconds off
Steady Red
Propane Alarm Constant beeping Flashing red
Alarm Malfunction Beep every 30
seconds
Alternating red/
green
End of Life Beep every 20-30
seconds
Red, red, green,
green flashing
Warm-Up Cycle No sound Flashing green
Test this alarm’s operation after each
storage period, before each trip and at least
once per week during use.
Smoke Alarm
The smoke alarm (1) sounds whenever there is
an unsafe amount of smoke in the motorhome.
Always open the roof vent before cooking.
● Open doors, windows, and roof vents to
air out motorhome and silence the alarm.
Identify and eliminate the source of the
smoke.
● Replace the battery at least once per year,
and test the battery after replacement.
Remove the cover to replace the battery.
● Clean and vacuum opening on smoke
alarm once a month.
Do not remove the battery to silence the
alarm. If the alarm “beeps” every minute, the
battery is weak and requires replacement.
Do not allow the battery to go dead. Use
only recommended replacement batteries
( see Smoke Detector operator’s manual
in Motorhome Information Kit for detailed
instructions ).
● Test the smoke alarm before each trip by
depressing the test button (2). Test the
smoke alarm after removing the motorhome
from storage, before each trip, and weekly
thereafter. Test the smoke alarm sensor
by blowing smoke (from a safe, fire-free
source) past the sensor. If the alarm does
not sound, identify and correct the source
of the problem or replace the smoke alarm.
● Make sure the wires are properly connected.
Position and close cover.
● If you suspect the smoke alarm is not
functioning properly, replace the alarm - do
NOT attempt to repair it.
NOTICE
Smoke alarms are not perfect and do not
respond in all situations. The best safeguard
is fire prevention.
● Clean and vacuum opening on smoke
alarm once a month.
● If you suspect the smoke alarm is not
functioning properly, replace the alarm - do
NOT attempt to repair it.
1
2
Warning
Warning