Leisure Temp LT1000, Руководство по установке

Страница: 16 / 72

Page - 13
1.4.d In-Line Chlorine Feeders
Place in-line chlorinators downstream from the heat pump and as low in elevation as possible.
l
If an erosion type feeder is used, it is recommended that a Hartford Loop be installed to protect internal heat
pump components.
l
A Hartford Loop is not necessary with a Salt Chlorine Generator.
Heat Pump with Hartford Loop
1.4.e Water Flow Rates
Maintain water flow rates as indicated. Please note, these specifications relate to the heat pump only. Code-
specified whole system turnover rates must be satisfied.
NOTICE
Failure to heed the following may result in damage to equipment.
l
Water flow exceeding maximum flow rates will negatively affect the total pool filtration performance and may
damage the heat pump. This will not be covered under the equipment warranty.
MODEL
FLOW RATES
MINIMUM MAXIMUM
LT55 20 GPM (75.7 L/min) 45 GPM (170 L/min)
LT400 20 GPM (75.7 L/min) 45 GPM (170 L/min)
LT600 20 GPM (75.7 L/min) 45 GPM (170 L/min)
LT700 30 GPM (113.6 L/min) 70 GPM (265 L/min)
LT800 30 GPM (113.6 L/min) 70 GPM (265 L/min)
LT1000 30 GPM (113.6 L/min) 70 GPM (265 L/min)
PLEASE NOTE -
If minimum flow rates are not met, heat pump performance is reduced and performance will
suffer. Internal safety devices may deactivate the heat pump with the following errors:
l
HIGH PRESSURE FAULT
l
HP5 SYSTEM LOCKOUT
l
LOW PRESSURE FAULT
l
LP5 SYSTEM LOCKOUT
1
-
Ins
ta
ll
at
ion