BURN ANTHRACITE COAL ONLY
WARNING - Risk of Fire:- Do not operate with flue draft exceeding
-.07 in
. water column.
Operating at a number above -.07 can cause solid fuel devices to burn back into the hopper.
- Do on operate with fuel loading or ash removal doors open.
- Do not store fuel or other combustible material within marked installation clearances.
- Inspect and clean flues and chimney regularly.
DANGER - Risk of Fire or Explosion - Do not burn garbage, gasoline, drain oil or other flammable liquids.
CAUTION
- Hot Surfaces: - Keep children away. - Do not touch during operation.
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE
Please save these instructions
Lighting the furnace for the first time
Use only quality anthracite coal. Rice size is recommended, buckwheat can be substituted if rice is not available.
Do not use wood
pellets or any other fuel besides Anthracite coal of proper size.
1.
Caution there will be situations where there will be hot temperatures capable of causing severe burns.
Please wear a good heavy pair of gloves when necessary. Leather welder gloves work well. Also there will be
fumes and some smoke while the paint cures it should be minimal but may be necessary to open doors or
windows while this happens.
2.
Set set-point temp on thermostat to 5 or 10 degrees below room temp to get the FR to 0
3.
Install ashpan
4.
Install firestop ring at the end of the grate
5.
Place starter bag on grate
6.
Put desired amount of coal in the hopper
7.
Make sure to cover the starter bag with coal
8.
Light starter bag, not important to get a flame just as long as it has embers.
9.
Close fire door
10.
Turn on switch to Coal-Trol module
11.
After about 10 minutes knock starter ring into ashpan it can be removed later after it cools
12.
Refer to Coal-Trol manual for further setup, now is the best time to set the Min and Max fire
13.
Check the furnace to make sure things are operating as they should.
14.
Check draft with draft meter. Or use instructions supplied with barometric damper if type with calibrated
scale. Draft should be set to between -0.03 to -0.05 between barometric damper and unit.
15.
Combustion air if found necessary to adjust is done by limiting the inlet air to the combustion blower(s). If the
blower is equipped with a block off plate use it as a shutter and block off as necessary to see desired readings
on the gauge. If not already equipped with a block off plate foil tape can be used as an alternative.
16.
Enjoy the heat while saving money and using an American fuel burned in an American Product
Safety Instructions and Information
Important Warning Statements
Your Stove comes with one Carbon Monoxide Detector, It is recommended that there be one outside each sleeping area and at
least one per floor, read your CO manual completely before lighting stove
