OPERATION
LEISTER Groover
Operating condition
• Adjust the
tracking wheel (11)
with
spacers (12)
to the pitch as required when
using nap-rolls, or tiles.
• Fit the
ejector pipe (16)
and
dustbag (17)
.
• Adjust the groove depth.
– With your left hand push down the
handle (5)
of the drive unit up to the magnet
stop.
– With your right hand on the
control knob (8)
adjust the required groove depth
until approx. 3/4 of the material thickness is visible on the scale.
•
• Align the tool along the grooving line via the
adjustable guide roller (9)
and the
red
positioning arrows (22)
. Pay attention to the direction of cutting!
Operation
• Connect tool to the power supply.
•
Cutting speed switch (4)
set to position 1 or position 2 depend from material
thickness.
• Hold the groover by the
handle (5)
(left hand) and by the
hand rest (6)
(right
hand).
• Align the marking arrows on the tool (red) with the grooving line. The adjustable
guide roller (9)
should run inside the grooving line and the
rear roller (10)
in the
groove.
• Activate the
locking button(3)
. Switch on the
operating switch (2)
.
• Press the handle down to the magnet stop (grooving position).
• The Groover is easy to push forward and straight along the grooving line with
the
adjustable guide roller (9)
and the
rear roller (10)
.
• At the end of the groove, switch off the
operating switch (2)
and release the
handle (5)
. The tool will spring back into the starting position.
• If required set the
guide roller (9)
with the
locking screw (21)
and
adjustment
screw (20)
(grooving centre).
Changing the cutting blade
•
• Remove the
cutting blade cover (14)
.
• Remove the blade with a box spanner.
• Clean the hub of the tool as well as the cutting blade to be inserted.
• Insert and fit the cutting blade. Check that the cutting blade revolves freely.
• Refit the
cutting blade cover (14)
.
Caution: Unplug the tool !
Caution: The cutting blade run out !
Caution: Cutting blade can protude!
6
