RS-232 communication
The analysis software is supplied with connection cabling with which a PC
is connected to the encoder through the serial port. We recommend that PC
communication should not be connected during operation.
If the encoder is supplied
with cabling, we recommend
that the connection to the PC
should be effected via a D-SUB
connector (9-pole female), for
example in a terminal box in
accordance with Figure G.
Cable colour
Function
Pin D-sub
Grey / Pink
Rxd
3
Red / Blue
Txd
2
Blue
0
V
5
Connected to one another
4
6
8
A standard extension cable, 9-pole D-sub male to 9-pole D-sub female, can be
used between the PC and the above connection.
Note that the length between the encoder and the PC must not exceed 10 m.
ADS PC SOFTWARE
A PC program with which information from the encoder about the operating
conditions and any faults can be received is provided for communication
with the ADS encoder. Your PC is connected to the encoder via the serial port
using the special cable supplied or a standard RS-232 cable in accordance
with the example in the Installation Specifi cation. Communication takes
place with an RS-232 interface. Note that the maximum cable length
between the encoder and the PC is 10 m.
Content
• Diskette with PC software. Part No. 01290021
• Manual Advanced Diagnostic System.
• RS-232 cable 9-pole D-sub female – connector to the encoder.
Part No. 01209083
ADS encoder
Coupling Box
RS 232 communication
Incremental signals
Figure G
System requirements
• PC with at least a 486 processor.
• Windows 95, 98 or NT.
Installation
1. Insert the diskette in the diskette drive.
2. Select the diskette drive in the Program Manager.
3. Start the fi le..\setup.exe
4. Follow the instructions.
Confi guration of software
1. Start \Diagnostik.exe
Select
settings.
See Figure H.
2. Set the COM port that you are using.
Set the frequency with which you require the information to be updated
for repeated updating.
Indicate the language that you wish to use, Swedish or English.
It is also possible to communicate via a modem installed in Windows and
an RS-232 modem via the telephone line. The software then calls the
indicated telephone number and starts the communication when the
”Online” key is pressed. We recommend a maximum updating speed of
1.0 s when a modem is in use.
See Figure I.
Figure H
Figure I
6
7