Leigh F1, Руководство пользователя

Страница: 31 / 116

1
/
4
" Comb
1
/
2
" Comb
3
/
8
" Comb
5
/
16
" Comb
3
4
1
2
1
4
3
4
1
2
1
4
1/4"
1/2"
5/16 "
3/8 "
12mm Comb
8mm Comb 10mm Comb
25
Template Modes
Template pin hole icons denote the type of
joint and edge finish from each position.
See notes on symmetry and board widths,
chapter 5 page 33.
Throughout the manual, the proper pin
location for each step is highlighted with
red in an inset. Only the active parts of the
inch and millimetre decals will be shown.
Always read scales from directly overhead
to avoid parallax problems.
The active scale is
always on the right side
of each scale assembly.
Green scales are for box
joints.
Grey scales are for
rounded finger joints
and denote the thick-
ness of the vertical pin
board.
The inactive scale is always on the left side
of each scale assembly and is upside down.
Each scale has its own
mode icon represent-
ing the current joint
part being made.
There are four settings
for inch box joints, and
three for metric.
The specific settings for each scale are fully described in the appropriate chapters.