Leica TCS SP8 SMD, Руководство пользователя, Страница: 124 / 270

124
Selecting the Laser
15.1.4 Using Pulsed UV Lasers
1. Open the shutter for pulsed lasers.
2. Activate the 405 nm laser by moving the corresponding slider upwards ( Figure 106,
item 1
).
Figure 106: Settings for the UV lasers in Beam Path Settings
3. If no other pulsed laser is used, you can set the multifunction port ( MFP ) to Substrate
( Figure 106, item 2 .
4. Follow the settings from Table 18 if you are using additional pulsed lasers at the same
time.
15.1.5 Using a Pulsed White Light Laser
1. In the laser dialog in the Beam Path Settings , you can switch between the laser spectra
for conventional laser lines or the white light laser. In order to call up the laser spectrum
of the white light laser, click the
Switch to Whitelight button ( Figure 107 ).
Figure 107: Calling up the white light laser laser spectrum
2. Switch the white light laser to ON ( Figure 108, item 1 ). The red-colored ON button signals
that the shutter is open.
Then, a laser line appears in the laser spectrum.