Preparation
21
Using the AC Adaptor
You can use the camera without worrying
about battery discharge when it is
connected to a PC or printer if you use the
AC adaptor.
• Check that the camera is turned off.
• Close the flash.
1
Connect the AC cable.
2
Connect the DC cable
.
• Pull open the DC cable cover
and
then connect the DC cable to the
camera body using the same steps as
“Inserting/Removing the Battery” (P20).
Pull the DC cable through the opening
as shown in the illustration and then
close the battery door.
• Be careful not to catch the DC cable
when closing the battery door.
• Do not use any other AC adaptors except
the supplied one.
• Do not use any other DC cables except
the supplied one. If you use other DC
cables, it may cause a malfunction.
• The camera becomes warm during use.
This is not a malfunction.
• Disconnect the AC adaptor and DC cable
when the camera is not in use.
Inserting/Removing
the Card
• Check that the camera is turned off.
• Close the flash.
• Prepare a card.
1
Slide the card door to open it.
2
Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
A
1
PUSH TO
LOCK / EJECT
Содержание Digilux 3
Страница 1: ...LEICA DIGILUX 3 ...
Страница 133: ...Others 133 ...
Страница 134: ...Others 134 ...
Страница 135: ...Others 135 ...