Leica Captivate, Техническое справочное руководство

Страница: 919 / 1060

53 Leica Captivate - Base - Start base
53.1 Over known point
In this option, a known point stored in the job is used to set up the RTK base.
Select Leica Captivate - Base : Base setup
\
Over known point .
Type in the antenna height and select the antenna being used.
Key Description
Back To return to the previous panel.
Next To confirm the settings and to continue to the next panel.
Description of fields
Field Option Description
Antenna
height
Editable field The height of the antenna that is being used.
Base
antenna
Selectable list Leica Geosystems antennas are predefined
as default and can be selected from the list.
Default antennas contain an elevation-
dependent correction model. New antenna
correction models can be set up and trans-
ferred to the instrument using Infinity. Open
the list to define or edit antennas. Refer to
"23.2.2 Antennas" for information on anten-
nas.
Vertical off-
set
Display only The vertical offset of the measurement refer-
ence point.
Next step
Next
to access Select point over which base is setup .
Select the point to be used as base station.
☞ A point could already be stored in the design job either by manual
entry, by measuring or by transfer from Infinity.
☞ To create a point, open the selectable list for Point ID and press
New .
Description
Access
Over Known Point
Enter the antenna
height & select base
antenna
Select point over
which base is setup
Leica Captivate - Base - Start base 919