Leica apMK12, Руководство по эксплуатации и установке

Страница: 25 / 218

12 Version 1.5
Operation & Installation Manual Keypad & Display Description
GOTO
This function key allows you to quickly create a route from your present
position to one other waypoint. This single waypoint route can use an
existing waypoint from the Waypoint Bank, or you can quickly create
one by either defining the appropriate coordinates or specifying a
range and bearing.
Be careful when you use this selection, as it will erase your current
active route when it creates the new one. Read through the
ROUTE
and PLOT sections of this manual to find other ways to use this key
within an active route.
LIGHT
This function key allows you to quickly switch between two predeter-
mined display lighting conditions. You can have two daytime settings,
two night time settings, or a daytime/night time setting. Select the
CFG
function key and scroll down to the Lighting menu choice to make the
desired adjustments. Refer to the Configuration section of the manual
for a complete description of the Lighting menu options.
POWER ON/OFF
This function key turns the unit on and off. When depressed while the
unit is on, you will be prompted to select a
YES or NO softkey to
confirm your action. This is known as a software power off .
If the operating program should hang up for any reason, you can also
perform a
hardware power off by continuing to depress the power on/
off function key for about 5 seconds. When the GPS is turned off
using this technique, you can not reapply power for 10 seconds.
Note: An occasion may arise when you need to reset
the memory back to the factory default values.
Doing this will cause the CDU to lose all of your
defined settings, as well as all 2,000 of your
waypoints and routes. If you hold down the fifth
(right most) softkey when power is applied for
about two seconds, until you hear a key click,
then the memory will be reset.
8/13/01, 11:30 AM 12