Leibinger JET Rapid, Руководство по эксплуатации

Страница: 41 / 50

Page 39
Release R.1.02 High Speed Line
 Decline the print head into upfront position.
 Fill up Special Cleaner 77001-00020 into a spray bottle and spray it to the affected parts
for cleaning.
 Together with a small brush you can easily remove the pollution in the cleaning area.
Important assemblies which will be affected in their functionality during persist ink
deposition:
1. Charge Electrode
2. Deflection Plates
3. Guiding shafts for the Gutter Tube

 
Information
Due to some special ingredients of the cleaner, it is strongly
recommended to flush all the cleaned parts with tap water at the end
of the cleaning process.

Rinse off the cleaned parts with original solvent again, to avoid remaining of special
cleaner at the assemblies.
 In some cases, there will still remain some rest of ink into the slot from the charge
electrode. This could create some error messages, e.g. phasing error or error of drop
control.
To remove this rest of ink you can use a fine sand paper. With assistance of
this fine sand paper it is possible to clean the slot of the charge electrode.
Attention
Use only sand paper with a corn diameter of 400 and higher
3
1
2