LEI accessories PD-N, Руководство по установке

Страница: 6 / 8

4
(HIGH SPEED) (HIGH SPEED) (HIGH SPEED) (HIGH SPEED) (HIGH SPEED)
TRANSDUCER LOCATION TRANSDUCER LOCATION TRANSDUCER LOCATION TRANSDUCER LOCATION TRANSDUCER LOCATION
(TROLLING SPEEDS) (TROLLING SPEEDS)
(TROLLING SPEEDS) (TROLLING SPEEDS) (TROLLING SPEEDS)
TRANSDUCER LOCATION TRANSDUCER LOCATION TRANSDUCER LOCATION TRANSDUCER LOCATION TRANSDUCER LOCATION
Shoot-thru-hull Installation
1. Dry the chosen area thoroughly, then sand both the inside surface of
the hull and the face of the transducer with 100 grit sandpaper. The
surface of the hull must be flat so the entire transducer face is in
contact with the hull prior to bonding.
2. Make certain the area is clean, dry, and free of oil or grease. Build a
small dam out of caulking compound or RTV around the mounting
area. It should be at least 1/2" greater in diameter than the trans-
ducer. Use a good two-part epoxy that sets up rock hard. Do not use
5 minute or “fast setting” epoxy. Do not use RTV silicone rubber
adhesive or any other glue.
TRANSDUCER TRANSDUCER
TRANSDUCER TRANSDUCER TRANSDUCER
RTV DAM RTV DAM
RTV DAM RTV DAM RTV DAM
DEADRISE LESS THAN TEN DEADRISE LESS THAN TEN DEADRISE LESS THAN TEN DEADRISE LESS THAN TEN DEADRISE LESS THAN TEN
DEGREES DEGREES DEGREES DEGREES DEGREES